Futaba kabelset för mätning av extern Volt 

198 kr
Kontakta oss för leveranstid
Bevaka produkt

Ange din e-postadress nedan så meddelar vi dig när produkten finns i lager! Din e-postadress sparas i upp till 180 dagar.


För telemetri av Extern Volt upp till 70 Volt via R7003SB, R7008SB & R7018SB mottagare

Pefekt hjälpmedel för att få status på din drivacc när du flyger!



Used to connect a Futaba telemetry equipped receiver to an extra voltage port.


Cable, Fuse, Heat Shrink Tube and Instructions


Length: 700 mm


This voltage cable plugs into the R7008SB next to the antenna.

This measures the external voltage, such as the battery that is running a motor. The voltage will be displayed in the transmitter as "EXT-VOLT".

Maximum voltage is 70 volts.

Cable should be cut to desired length, then remove & save 30mm from the positive black line. Next, solder the fuse inline on the positive wire and reattach the section of wire that was previously removed and solder into place. The fuse should be attached as close to the external power supply as possible. Place shrink tubing over the fuse and cover all sodered areas. Shrink the tubing onto the wire with a heat gun. The cables will then be connected to corresponding + & - wires that connect the ESC to the battery and attached using solder and shrink tubing


Produkten har blivit tillagd i varukorgen

Gå till kassanFortsätt handla